Diameter Overload Rate Control
draft-donovan-dime-doc-rate-control-00
The information below is for an old version of the document.
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
---|---|---|---|
Authors | Steve Donovan , Eric Noel | ||
Last updated | 2014-08-18 (Latest revision 2014-02-14) | ||
Replaced by | draft-ietf-dime-doic-rate-control, RFC 8582 | ||
RFC stream | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This specification documents an extension to the Diameter Overload Control (DOC) base solution. This extension adds a new overload control algorithm. This algorithm allows for a server to specify a maximum rate at which Diameter requests are sent to the server. Requirements
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)