Assignment of an Ethertype for IPv6 with LoWPAN Encapsulation
draft-droms-6lo-ethertype-request-01
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Ralph Droms , Paul Duffy | ||
| Last updated | 2016-04-04 | ||
| Replaced by | RFC 7973 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-6lo-ethertype-request | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
When carried over layer 2 technologies such as Ethernet, IPv6 datagrams using LoWPAN encapsulation as defined in RFC 4944 must be identified so the receiver can correctly interpret the encoded IPv6 datagram. This document requests the assignment of an Ethertype for that purpose.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)