DHCPv4 bulk lease query
draft-dtv-dhc-dhcpv4-bulk-leasequery-00
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Pavan Kurapati | ||
| Last updated | 2008-07-01 | ||
| Replaced by | draft-ietf-dhc-dhcpv4-bulk-leasequery | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-dhc-dhcpv4-bulk-leasequery | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Dynamic Host Configuration Protocol for IPv4 (DHCPv4) has been extended with a Leasequery capability that allows a client to request information about DHCPv4 bindings. That mechanism is limited to queries for individual bindings. In some situations individual binding queries may not be efficient, or even possible. This document expands on the Leasequery protocol, adding new query types and allowing for bulk transfer of DHCPv4 binding data via TCP.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)