LDP Extensions for RMR
draft-esale-ldp-rmr-extensions-00
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Santosh Esale , Kireeti Kompella | ||
| Last updated | 2017-05-04 (Latest revision 2016-10-31) | ||
| Replaced by | draft-esale-mpls-ldp-rmr-extensions | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-esale-mpls-ldp-rmr-extensions | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes LDP extensions to signal Resilient MPLS Ring (RMR) Label Switched Paths (LSPs). An RMR LSP is a multipoint to point LSP signaled using LDP (Label Distribution Protocol). RMR Architecture document - draft-ietf-mpls-rmr-02 - describes why and how MPLS should be used in ring topologies.
Authors
Santosh Esale
Kireeti Kompella
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)