LDP Extensions for RMR
draft-esale-mpls-ldp-rmr-extensions-02
Document | Type | Replaced Internet-Draft (mpls WG) | |
---|---|---|---|
Authors | Santosh Esale , Kireeti Kompella | ||
Last updated | 2018-07-28 (latest revision 2018-05-20) | ||
Replaces | draft-esale-ldp-rmr-extensions | ||
Replaced by | draft-ietf-mpls-ldp-rmr-extensions | ||
Stream | Internent Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats |
Expired & archived
pdf
htmlized (tools)
htmlized
bibtex
|
||
Stream | WG state | Adopted by a WG | |
Document shepherd | No shepherd assigned | ||
IESG | IESG state | Replaced by draft-ietf-mpls-ldp-rmr-extensions | |
Consensus Boilerplate | Unknown | ||
Telechat date | |||
Responsible AD | (None) | ||
Send notices to | (None) |
https://www.ietf.org/archive/id/draft-esale-mpls-ldp-rmr-extensions-02.txt
Abstract
This document describes LDP extensions to signal Resilient MPLS Ring (RMR) Label Switched Paths (LSPs). An RMR LSP is a multipoint to point LSP signaled using LDP (Label Distribution Protocol). RMR Architecture document - draft-ietf-mpls-rmr-02 - describes why and how MPLS should be used in ring topologies.
Authors
Santosh Esale
(sesale@juniper.net)
Kireeti Kompella
(kireeti@juniper.net)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)