LDP Extensions for RMR
draft-esale-mpls-ldp-rmr-extensions-01
| The information below is for an old version of the document | |||
|---|---|---|---|
| Document | Type | Expired Internet-Draft (individual) | |
| Authors | Santosh Esale , Kireeti Kompella | ||
| Last updated | 2018-04-19 (latest revision 2017-09-07) | ||
| Replaced by | draft-ietf-mpls-ldp-rmr-extensions | ||
| Stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats |
Expired & archived
pdf
htmlized (tools)
htmlized
bibtex
|
||
| Stream | Stream state | (No stream defined) | |
| Consensus Boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | |||
| Responsible AD | (None) | ||
| Send notices to | (None) | ||
https://www.ietf.org/archive/id/draft-esale-mpls-ldp-rmr-extensions-01.txt
Abstract
This document describes LDP extensions to signal Resilient MPLS Ring (RMR) Label Switched Paths (LSPs). An RMR LSP is a multipoint to point LSP signaled using LDP (Label Distribution Protocol). RMR Architecture document - draft-ietf-mpls-rmr-02 - describes why and how MPLS should be used in ring topologies.
Authors
Santosh Esale
(sesale@juniper.net)
Kireeti Kompella
(kireeti@juniper.net)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)