LISP Geo-Coordinate Use-Cases
draft-farinacci-lisp-geo-03

Document Type Active Internet-Draft (candidate for lisp WG)
Last updated 2017-06-28 (latest revision 2017-04-28)
Stream IETF
Intended RFC status (None)
Formats plain text pdf html bibtex
Stream WG state Call For Adoption By WG Issued
Document shepherd No shepherd assigned
IESG IESG state I-D Exists
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)
Network Working Group                                       D. Farinacci
Internet-Draft                                               lispers.net
Intended status: Experimental                             April 28, 2017
Expires: October 30, 2017

                     LISP Geo-Coordinate Use-Cases
                      draft-farinacci-lisp-geo-03

Abstract

   This draft describes how Geo-Coordinates can be used in the LISP
   Architecture and Protocols.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on October 30, 2017.

Copyright Notice

   Copyright (c) 2017 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Farinacci               Expires October 30, 2017                [Page 1]
Internet-Draft        LISP Geo-Coordinate Use-Cases           April 2017

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
   2.  Definition of Terms . . . . . . . . . . . . . . . . . . . . .   2
   3.  Geo-Points in RLOC-records  . . . . . . . . . . . . . . . . .   3
   4.  Geo-Prefixes in EID-records and RLOC-records  . . . . . . . .   3
   5.  Geo-Prefix and Geo-Point Encodings  . . . . . . . . . . . . .   5
   6.  Security Considerations . . . . . . . . . . . . . . . . . . .   7
   7.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   7
   8.  References  . . . . . . . . . . . . . . . . . . . . . . . . .   7
     8.1.  Normative References  . . . . . . . . . . . . . . . . . .   7
     8.2.  Informative References  . . . . . . . . . . . . . . . . .   8
   Appendix A.  Acknowledgments  . . . . . . . . . . . . . . . . . .   9
   Appendix B.  Document Change Log  . . . . . . . . . . . . . . . .   9
     B.1.  Changes to draft-farinacci-lisp-geo-03.txt  . . . . . . .   9
     B.2.  Changes to draft-farinacci-lisp-geo-02.txt  . . . . . . .   9
     B.3.  Changes to draft-farinacci-lisp-geo-01.txt  . . . . . . .   9
     B.4.  Changes to draft-farinacci-lisp-geo-00.txt  . . . . . . .  10
   Author's Address  . . . . . . . . . . . . . . . . . . . . . . . .  10

1.  Introduction

   The LISP architecture and protocols [RFC6830] introduces two new
   numbering spaces, Endpoint Identifiers (EIDs) and Routing Locators
   (RLOCs) which are intended to replace most use of IP addresses on the
   Internet.  To provide flexibility for current and future
   applications, these values can be encoded in LISP control messages
   using a general syntax that includes Address Family Identifier (AFI)
   [RFC1700].

   This specification introduces the use of Geo-Coordinates that can be
   used in EID-records and RLOC-records of LISP control messages.  The
   encoding format is specified in [RFC8060] as the "Geo-Coordinates
   LCAF Type".

2.  Definition of Terms

   Geo-Point  is a Geo-Coordinate according to [GEO] that defines a
      point from parameters Latitude, Longitude, and Altitude.

   Geo-Prefix  forms a circle of a geographic area made up of a Geo-
      Point and a Radius.  A Geo-Point is known to be "more-specific"
      than a Geo-Prefix when its physical location is within the
      geographic circle.

Farinacci               Expires October 30, 2017                [Page 2]
Internet-Draft        LISP Geo-Coordinate Use-Cases           April 2017

3.  Geo-Points in RLOC-records

   Geo-Points can accompany an RLOC-record to determine the physical
   location of an ETR or RTR.  This can aid in determining geographical
   distance when topological distance is inaccurate or hidden.  When
Show full document text