PCEP Extensions to support BFD parameters
draft-fizgeer-pcep-bfd-parameters-00
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Orly Bachar , Marina Fizgeer | ||
| Last updated | 2022-12-15 | ||
| Replaces | draft-fizgeer-pce-lsp-parameters | ||
| Replaced by | draft-fizgeer-pce-pcep-bfd-parameters | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-fizgeer-pce-pcep-bfd-parameters | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document proposes extension to PCEP to configure LSP parameters. Some of LSP parameters are needed to configure S-BFD for candidate paths. Each candidate path is identified in PCEP by its uniquely assigned PLSP-ID. The mechanism proposed in this document is applicable to to all path setup types. The need for these definitions first appeared for Segment Routing path setup type, both MPLS and IPv6 data planes of SR.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)