Skip to main content

A Packet Loss and Delay Measurement Profile for MPLS-based Transport Networks
draft-frost-mpls-tp-loss-delay-profile-00

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Dan Frost , Stewart Bryant
Last updated 2012-10-10 (Latest revision 2010-12-15)
Replaced by draft-ietf-mpls-tp-loss-delay-profile
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-mpls-tp-loss-delay-profile
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Procedures for the measurement of packet loss, delay, and throughput in MPLS networks are defined in RFC XXXX. This document describes a profile, i.e. a simplified subset, of these procedures that suffices to meet the specific requirements of MPLS-based transport networks. This document is a product of a joint Internet Engineering Task Force (IETF) / International Telecommunication Union Telecommunication Standardization Sector (ITU-T) effort to include an MPLS Transport Profile within the IETF MPLS and Pseudowire Emulation Edge-to-Edge (PWE3) architectures to support the capabilities and functionalities of a packet transport network as defined by the ITU-T. [RFC Editor, please remove this note before publication as an RFC and insert the correct Streams Boilerplate to indicate that the published RFC has IETF consensus.]

Authors

Dan Frost
Stewart Bryant

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)