Packet Loss and Delay Measurement for the MPLS Transport Profile
draft-frost-mpls-tp-loss-delay-02

Document Type Replaced Internet-Draft (individual)
Authors Dan Frost  , Stewart Bryant 
Last updated 2010-08-03 (latest revision 2010-06-29)
Replaced by draft-ietf-mpls-tp-loss-delay
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-mpls-tp-loss-delay
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-frost-mpls-tp-loss-delay-02.txt

Abstract

An essential Operations, Administration and Maintenance requirement of the MPLS Transport Profile (MPLS-TP) is the ability to monitor performance metrics for packet loss and one-way and two-way delay for MPLS-TP pseudowires, Label Switched Paths, and Sections. This document specifies protocol mechanisms to facilitate the efficient and accurate measurement of these performance metrics.

Authors

Dan Frost (danfrost@cisco.com)
Stewart Bryant (stbryant@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)