Packet Loss and Delay Measurement for the MPLS Transport Profile
draft-frost-mpls-tp-loss-delay-02
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Dan Frost , Stewart Bryant | ||
| Last updated | 2010-08-03 (Latest revision 2010-06-29) | ||
| Replaced by | draft-ietf-mpls-tp-loss-delay | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-mpls-tp-loss-delay | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
An essential Operations, Administration and Maintenance requirement of the MPLS Transport Profile (MPLS-TP) is the ability to monitor performance metrics for packet loss and one-way and two-way delay for MPLS-TP pseudowires, Label Switched Paths, and Sections. This document specifies protocol mechanisms to facilitate the efficient and accurate measurement of these performance metrics.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)