Skip to main content

Requirement for Multi Stages Multiplexing Configuration in G.709 Optical Transport Network

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Xihua Fu , Malcolm Betts , Ruiquan Jing , Xiaoli Huo , Han Li , China Unicom , Guoying Zhang
Last updated 2010-07-11
RFC stream (None)
Intended RFC status (None)
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:


Interworking between regions with 1.25G TS and 2.5G TS has been considered in G.709. Multi stages multiplexing/demultiplexing would be desirable to facilitate the introduction of new ODU0 and ODUflex signals to an existing network without having to upgrade every node in the network. So ODU0/ODUflex can be mapped into ODU1/ODU2/ODU3 and transit across the 2.5G TS region. Multi stages multiplexing/demultiplexing are also used to support the multi-domain OTN applications based on the tunnel design. If there are a large number of circuits that share the same endpoints (or even part of an overall path), it may be convenient from a management perspective to first multiplex those ODU0, ODU1 and ODUflex into ODU2 or ODU3 to minimize the number of connections that need to be made in intermediate nodes. The ODU2/ODU3 effectively creates a tunnel through the ODU4 network that the ODU0, ODU1 and ODUflex can use. This document describes the requirement of multi stages multiplexing configuration assocaited with some specific scenarios in G.709 Optical Transport Network.


Xihua Fu
Malcolm Betts
Ruiquan Jing
Xiaoli Huo
Han Li
China Unicom
Guoying Zhang

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)