IPv6 over Low-Power Wireless Personal Area Network (6LoWPAN) Dispatch Type for SCHC
draft-gomez-6lo-schc-dispatch-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Carles Gomez | ||
| Last updated | 2021-03-25 (Latest revision 2020-09-21) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
A new framework called Static Context Header Compression (SCHC) has been designed with the primary goal of supporting IPv6 over Low Power Wide Area Network (LPWAN) technologies [RFC8724]. One of the SCHC components is a header compression mechanism. If used properly, SCHC header compression allows a greater compression ratio than that achievable with traditional 6LoWPAN header compression [RFC6282]. For this reason, it may make sense to use SCHC header compression in some 6LoWPAN environments. This document defines a 6LoWPAN Dispatch Type to signal when a packet header has been compressed by using SCHC header compression.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)