A Mechanism to Measure the Quality of a Point-to-point Route in a Low Power and Lossy Network
draft-goyal-roll-p2p-measurement-01
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Mukul Goyal , Emmanuel Baccelli | ||
| Last updated | 2013-02-19 (Latest revision 2010-10-25) | ||
| Replaced by | draft-ietf-roll-p2p-measurement | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-roll-p2p-measurement | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies a mechanism that enables an RPL node to measure the quality of an existing route to/from another RPL node in a low power and lossy network, thereby allowing the node to decide if it wants to initiate the discovery of a more optimal route.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)