V.92 Modem-On-Hold signalling on L2TP
draft-goyret-l2tpext-v92-moh-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Ignacio Goyret | ||
Last updated | 2002-03-26 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Layer 2 Tunneling Protocol [L2TP] defines a mechanism for tunneling PPP [PPP] sessions. One of the features introduced by V.92 [V92] is the ability of the client modem to put the call on hold. The L2TP base protocol does not provide any means to signal this event. This document describes a method used to indicate when a client modem has gone on-hold.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)