Signal Degrade Indication Used in Segment Routing over MPLS Network
draft-han-mpls-sdi-sr-00
The information below is for an old version of the document.
| Document | Type | Expired Internet-Draft (individual) | |
|---|---|---|---|
| Authors | Liuyan Han , Fan Yang | ||
| Last updated | 2021-01-14 (Latest revision 2020-07-13) | ||
| Stream | (None) | ||
| Formats |
Expired & archived
plain text
htmlized
pdfized
bibtex
|
||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of
the expired Internet-Draft can be found at:
https://www.ietf.org/archive/id/draft-han-mpls-sdi-sr-00.txt
https://www.ietf.org/archive/id/draft-han-mpls-sdi-sr-00.txt
Abstract
This document describes the typical use cases for signal degrade indication used in SR over MPLS networks. To satisfy the use cases and requirements of signal degrade indication, two extensions based on the BFD protocol and MPLS-TP OAM mechanisms are given respectively.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)