Skip to main content

Yang Data Model for PPPoE Protocol
draft-han-netmod-intf-ext-pppoe-yang-00

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Author Hansance Han
Last updated 2017-09-19
RFC stream (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state I-D Exists
Telechat date (None)
Responsible AD (None)
Send notices to (None)
draft-han-netmod-intf-ext-pppoe-yang-00
Internet Engineering Task Force                            Hansance Han
Internet Draft                                                 Ericsson
Intended status: Standards Track                           Kevin Huang M
                                                                Ericsson
Expires: June 2018                                   September 19, 2017

                    Yang Data Model for PPPoE Protocol
                draft-han-netmod-intf-ext-pppoe-yang-00.txt

Abstract

   This document defines a YANG data model that can be used to
configure and manage PPPoE.

Status of this Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF), its areas, and its working groups.  Note that
   other groups may also distribute working documents as Internet-
   Drafts.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   The list of current Internet-Drafts can be accessed at
   http://www.ietf.org/ietf/1id-abstracts.txt

   The list of Internet-Draft Shadow Directories can be accessed at
   http://www.ietf.org/shadow.html

   This Internet-Draft will expire on August 19, 2017.

Copyright Notice

   Copyright (c) 2017 IETF Trust and the persons identified as the
   document authors. All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document. Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document. Code Components extracted from this document must

Hansance&Kevin          Expires June 19, 2018                  [Page 1]
Internet-Draft          PPPoE Yang Data Model            September 2017

   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1. Introduction...................................................2
      1.1. Terminology...............................................2
      1.2. Tree Diagrams.............................................3
   2. Design of Data Model...........................................3
      2.1. Overview..................................................3
   3. PPPoE YANG Module..............................................4
   4. Security Considerations........................................8
   5. IANA Considerations............................................8
   6. Normative References...........................................8
   7. Appendix A.  Change Log........................................8

1. Introduction

   This document defines a YANG [RFC6020] data model for the management
   of PPPoE protocol.

   This data model includes configuration data and state data (status
   information and counters for the collection of statistics).

1.1. Terminology

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and
   "OPTIONAL" in this document are to be interpreted as described in BCP
   14 [RFC2119].

   The following terms are used within this document:

   The following terms are defined in [RFC6241] and are not redefined
   here:

   o  client

   o  configuration data

   o  server

   o  state data

Hansance&Kevin          Expires June 19, 2018                  [Page 2]
Internet-Draft          PPPoE Yang Data Model            September 2017

   The following terms are defined in [RFC6020] and are not redefined
   here:

   o  augment

   o  data model

   o  data node

   o  presence container

1.2. Tree Diagrams

   A simplified graphical representation of the data model is used in
   this document.  The meaning of the symbols in these diagrams is as
   follows:

   o  Brackets "[" and "]" enclose list keys.

   o  Abbreviations before data node names: "rw" means configuration
   (read-write), and "ro" means state data (read-only).

   o  Symbols after data node names: "?" means an optional node, "!"
   means a presence container, and "*" denotes a list and leaf-list.

   o  Parentheses enclose choice and case nodes, and case nodes are also
   marked with a colon (":").

   o  Ellipsis ("...") stands for contents of subtrees that are not
   shown.

2. Design of Data Model

   The goal of this document is to define a data model that provides a
   common user interface to the PPPoE protocol.  There is very
   information that is designated as "mandatory", providing freedom for
   vendors to adapt this data model to their respective product
   implementations.

2.1. Overview

   The PPPoE YANG module defined in this document has all the common
   building blocks for the PPPoE protocol.

   module: ietf-if-ex-pppoe
   augment /if:interfaces/if:interface:
      +--rw pppoe!
         +--rw pppoe-mode-type?   enumeration
         +--rw pppoe-server! {pppoe-server}?

Hansance&Kevin          Expires June 19, 2018                  [Page 3]
Internet-Draft          PPPoE Yang Data Model            September 2017

         |  +--rw enabled?          boolean
         |  +--rw remote-ip-pool! {remote-ip-pool}?
         |  |  +--rw (address-pool)
         |  |     +--:(ip-pool)
         |  |     |  +--rw ip-pool?        inet:ip-prefix
         |  |     +--:(ip-pool-name)
         |  |        +--rw ip-pool-name?   string
         |  +--rw authentication! {pppoe-authentication}?
         |     +--rw (authentication-mode)
         |        +--:(pap)
         |        |  +--rw pap?    empty
         |        +--:(chap)
         |           +--rw chap?   empty
         +--rw pppoe-client! {pppoe-client}?
            +--rw enabled?   boolean

3. PPPoE YANG Module

   <CODE BEGINS> file "intf-if-ext-pppoe@2017-09-19.yang"
   module ietf-if-ex-pppoe {
        namespace "urn:ietf:params:xml:ns:yang:iana-if-type-pppoe";
        prefix "pppoe";

        import ietf-interfaces {
          prefix if;
        }

        import ietf-inet-types {
          prefix "inet";
        }

        organization
          "IETF NETMOD (NETCONF Data Modeling Language) Working Group";

        contact
          "Editor:   Hansance Han
                     <mailto:hansance.han@ericsson.com
           Editor:   Kevin Huang M
                     <mailto:kevin.m.huang@ericsson.com>";

         description
                "This module contains a collection of YANG definitions
   for
                 managing PPPoE network interfaces.";

         revision 2017-09-19 {
           description
             "Initial revision.";
           reference

Hansance&Kevin          Expires June 19, 2018                  [Page 4]
Internet-Draft          PPPoE Yang Data Model            September 2017

             "RFC 7223: A YANG Data Model for Interface Management";
         }

         feature pppoe {
           description
             "Indicates that the interface supports configuration of
   pppoe.";
         }

         feature pppoe-server {
           description
             "Indicates that the PPPoE supports server mode.";
         }

         feature pppoe-client {
           description
             "Indicates that the PPPoE support client mode.";
         }

         feature remote-ip-pool {
           description
             "Indicates that the PPPoE server support IPv4 and IPv6
   address pool.";
         }

         feature pppoe-authentication {
           description
             "Indicates that the interface supports configuration of
              pppoe authentication.";
         }

         augment "/if:interfaces/if:interface" {
          when "if:type = 'ppp'";

          description
          "PPPoE link protocol is extension under interface.";

          container pppoe {
            presence "";
            description
              "A pppoe interface must specify the PPPoE parameters.";

            leaf pppoe-mode-type {
              type enumeration {
                enum server {
                  description
                    "To configure device to operate in the PPPoE server
   mode.";
                }

Hansance&Kevin          Expires June 19, 2018                  [Page 5]
Internet-Draft          PPPoE Yang Data Model            September 2017

                enum client {
                  description
                    "To configure device to operate in the PPPoE client
   mode.";
                }
              }
              default server;
              description
                "The desired mode type for this PPPoE connection mode.";
            }

            container pppoe-server {
              if-feature pppoe-server;
              presence "";
              description
              "The PPPoE server configuration subtree.";

              leaf enabled {
                type boolean;
                default "false";
                description
                  "This leaf contains the configured, desired state of
   the PPPoE.";
              }

              container remote-ip-pool {
                if-feature remote-ip-pool;
                presence "";
                description
                "The PPPoE server support IPv4 and IPv6 address pool for
   remote
                client device";

               choice address-pool {
                 mandatory true;
                 description
                 "The address-pool for IPv4/IPv6 adress and IP pool
   name.";
                 case ip-pool {
                  leaf ip-pool {
                    type inet:ip-prefix;
                    description
                    "An IPv4/IPv6 prefix used for PPPoE remote IPv4/IPv6
                    pool purposes.";
                  }
                 }
                 case ip-pool-name {
                  leaf ip-pool-name {
                    type string {

Hansance&Kevin          Expires June 19, 2018                  [Page 6]
Internet-Draft          PPPoE Yang Data Model            September 2017

                      length "1..64";
                    }
                    description "Name of the IP pool";
                  }
                 }
                }
              }

              container authentication {
                if-feature pppoe-authentication;
                presence "";
                description
                "The authentication configuration subtree.";

                choice authentication-mode {
                  mandatory true;
                  description
                  "The authentication sub-mode pap and chap.";
                  case pap {
                    leaf pap {
                      type empty;
                      description
                      "Authentication pap for PPPoE.";
                    }
                  }
                  case chap {
                    leaf chap {
                      type empty;
                      description
                      "Authentication pap for PPPoE.";
                    }
                  }
                }
              }
            }

            container pppoe-client {
              if-feature pppoe-client;
              presence "";
              description
              "The PPPoE server configuration subtree.";
              leaf enabled {
                type boolean;
                default "false";
                description
                  "This leaf contains the configured, desired state of
   the PPPoE.";
              }
            }

Hansance&Kevin          Expires June 19, 2018                  [Page 7]
Internet-Draft          PPPoE Yang Data Model            September 2017

            // other PPPoE specific params...
           }
         }
       }
   <CODE ENDS>

4. Security Considerations

   The data model defined does not create any security implications.

5. IANA Considerations

   This draft does not request any IANA action.

6. Normative References

   [RFC7224] M. Bjorklund, "IANA Interface Type YANG model", RFC 7224
             May 2014, <https://tools.ietf.org/html/rfc7224>.

   [RFC1661] Simpson, W., "The Point-to-Point Protocol(PPP)", STD 51,
             RFC 1661, July 1999, <https://tools.ietf.org/html/rfc1661>.

   [RFC6020] Bjorklund, M., Ed., "YANG - A Data Modeling Language for
             the Network Configuration Protocol (NETCONF)", RFC 6020,
             DOI 10.17487/RFC6020, October 2010, <http://www.rfc-
             editor.org/info/rfc6020>.

   [RFC6021] Schoenwaelder, J., Ed., "Common YANG Data Types", RFC 6021,
             DOI 10.17487/RFC6021, October 2010, <http://www.rfc-
             editor.org/info/rfc6021>.

7. Appendix A.  Change Log

Hansance&Kevin          Expires June 19, 2018                  [Page 8]
Internet-Draft          PPPoE Yang Data Model            September 2017

   Authors' Addresses

   Hansance Han
   Ericsson (China) Communications Company Ltd.
   Ericsson Tower, No. 5 Lize East Street,
   Chaoyang District Beijing 100102, P.R. China

   Email: hansance.han@ericsson.com

   Kevin Huang M
   Ericsson (China) Communications Company Ltd.
   Ericsson Tower, No. 5 Lize East Street,
   Chaoyang District Beijing 100102, P.R. China

   Email: kevin.m.huang@ericsson.com

Hansance&Kevin          Expires June 19, 2018                  [Page 9]