ICCP extension for the MSP application
draft-hao-pwe3-iccp-extension-for-msp-04
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Hongjie Hao , Ma Yuxia , Weiqiang Cheng , Daniel Cohn , Masahiro Daikoku | ||
| Last updated | 2013-04-25 (Latest revision 2012-10-22) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies extensions to the Inter-Chassis Communication Protocol (ICCP) to support inter-chassis linear multiplex section protection (MSP) as described in G.841 and automatic protection switching as defined in ANSI T1.105.01. This document considers an application where a CE device or access network is attached to two PEs through Synchronous Digital Hierarchy (SDH) circuits, and MSP or APS is used to protect the attachment circuits. ICCP is used to support configuration and state synchronization between two chassis. CE device or access network attached to more than two PEs is out of the scope of this document.
Authors
Hongjie Hao
Ma Yuxia
Weiqiang Cheng
Daniel Cohn
Masahiro Daikoku
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)