A Two-way Active Measurement Protocol (TWAMP)
draft-hedayat-two-way-active-measurement-protocol-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Kaynam Hedayat | ||
| Last updated | 2005-07-14 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The IPPM One-way Active Measurement Protocol [OWAMP] provides a common protocol for measuring one-way metrics between network devices. OWAMP [OWAMP] can be used in both directions independently to measure one-way metrics in both directions between two network elements. However, it does not accommodate round-trip or two-way measurements. This draft proposes a Two-way Active Measurement Protocol, based on the One-way Active Measurement Protocol [OWAMP], that will accommodate two-way or round-trip measurements.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)