MPLS-TP Ring Protection Switching (MRPS)
draft-helvoort-mpls-tp-ring-protection-switching-06
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Huub van Helvoort , Jeong-dong Ryoo | ||
| Last updated | 2014-10-19 (Latest revision 2014-04-17) | ||
| Replaces | draft-umansky-mpls-tp-ring-protection-switching | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a mechanism to address the requirements for protection of the Multi-Protocol Label Switching Transport Profile (MPLS-TP) Label Switched Paths (LSP) in a ring topology. The mechanism defined herein is designed to support point-to-point as well as point-to-multipoint LSPs. The MPLS-TP section layer OAM is used to monitor the connectivity between each two adjacent nodes using the mechanisms defined in the [RFC6371]. The Automatic Protection Switching (APS) protocol is used for coordination of protection switching actions between the ring nodes.
Authors
Huub van Helvoort
Jeong-dong Ryoo
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)