Skip to main content

Definition of Managed Objects for the Lightweight On-demand Ad hoc Distance-vector Routing Protocol - Next Generation (LOADng)
draft-herberg-lln-loadng-mib-04

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Ulrich Herberg , Robert Cole , Thomas H. Clausen
Last updated 2015-01-05 (Latest revision 2014-07-04)
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This memo defines a portion of the Management Information Base (MIB) for use with network management protocols in the Internet community. In particular, it describes objects for configuring parameters of the Lightweight On-demand Ad hoc Distance-vector Routing Protocol - Next Generation (LOADng) process on a router. The MIB module defined in this memo, denoted LOADng-MIB, also reports state. While LOADng is layer agnostic and can be run with different address families (e.g., on L2 using MAC addresses, or on L3 using IP address), this MIB module assumes that LOADng is used on L3, and uses only IPv4/IPv6 addresses.

Authors

Ulrich Herberg
Robert Cole
Thomas H. Clausen

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)