RTP Payload Format for Bluetooth's SBC audio codec
draft-hoene-avt-rtp-sbc-05
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Christian Hoene , Frans de Bont | ||
Last updated | 2010-06-14 (Latest revision 2009-12-15) | ||
Replaced by | draft-ietf-avt-rtp-sbc | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-avt-rtp-sbc | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies a Real-time Transport Protocol (RTP) payload format to be used for the low complexity subband codec (SBC), which is the mandatory audio codec of the Advanced Audio Distribution Profile (A2DP) Specification written by the Bluetooth(r) Special Interest Group (SIG). The payload format is designed to be able to interoperate with existing Bluetooth A2DP devices, to provide high streaming audio quality, interactive audio transmission over the internet, and ultra-low delay coding for jam sessions on the internet. This document contains also a media type registration which specifies the use of the RTP payload format.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)