YANG Data Model for the IS-IS Reverse Metric Extension
draft-hopps-lsr-yang-isis-reverse-metric-00
The information below is for an old version of the document.
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
|
|
|---|---|---|---|
| Author | Christian Hopps | ||
| Last updated | 2019-03-31 | ||
| Replaced by | draft-ietf-lsr-yang-isis-reverse-metric, RFC 9194 | ||
| RFC stream | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | I-D Exists | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
draft-hopps-lsr-yang-isis-reverse-metric-00
Network Working Group C. Hopps
Internet-Draft LabN Consulting, L.L.C.
Intended status: Standards Track 31 March 2019
Expires: 2 October 2019
YANG Data Model for the IS-IS Reverse Metric Extension
draft-hopps-lsr-yang-isis-reverse-metric-00
Abstract
This document defines a YANG module for managing the reverse metric
extension to the the intermediate system to intermediate system
routeing protocol.
Status of This Memo
This Internet-Draft is submitted in full conformance with the
provisions of BCP 78 and BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF). Note that other groups may also distribute
working documents as Internet-Drafts. The list of current Internet-
Drafts is at https://datatracker.ietf.org/drafts/current/.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
This Internet-Draft will expire on 2 October 2019.
Copyright Notice
Copyright (c) 2019 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents (https://trustee.ietf.org/
license-info) in effect on the date of publication of this document.
Please review these documents carefully, as they describe your rights
and restrictions with respect to this document. Code Components
extracted from this document must include Simplified BSD License text
as described in Section 4.e of the Trust Legal Provisions and are
provided without warranty as described in the Simplified BSD License.
Table of Contents
1. Introduction
2. YANG Management
2.1. YANG Tree
2.2. YANG Module
3. IANA Considerations
3.1. Updates to the IETF XML Registry
3.2. Updates to the YANG Module Names Registry
4. Security Considerations
5. Normative References
6. Informative References
Author's Address
1. Introduction
This document defines a YANG module for managing the reverse metric
extension to the intermediate system to intermediate system routeing
protocol (IS-IS) [RFC8500], [ISO10589]. Please refer to [RFC8500]
for the description and definition of the functionality managed by
this module.
The YANG data model described in this document conforms to the
Network Management Datastore Architecture defined in [RFC8342].
2. YANG Management
2.1. YANG Tree
The following is the YANG tree diagram ([RFC8340]) for the IS-IS
reverse metric extension additions.
module: ietf-isis-reverse-metric
augment /rt:routing/rt:control-plane-protocols
/rt:control-plane-protocol/isis:isis/isis:interfaces
/isis:interface:
+--rw reverse-metric
+--rw reverse-metric
| +--rw metric? isis:wide-metric
| +--rw flags? bits
+--rw exclude-te-metric? boolean
augment /rt:routing/rt:control-plane-protocols
/rt:control-plane-protocol/isis:isis/isis:interfaces
/isis:interface/isis:adjacencies/isis:adjacency:
+--ro reverse-metric
| +--ro metric? isis:wide-metric
| +--ro flags? bits
+--ro te-metric? uint32
2.2. YANG Module
The following is the YANG module for managing the IS-IS reverse
metric functionality defined in [RFC8500].
<CODE BEGINS> file "ietf-isis-reverse-metric@2019-03-31.yang"
module ietf-isis-reverse-metric {
yang-version 1.1;
namespace "urn:ietf:params:xml:ns:yang:ietf-isis-reverse-metric";
prefix isis-rmetric;
import ietf-isis { prefix isis; }
import ietf-routing { prefix "rt"; }
organization
"IETF NETMOD Working Group (NETMOD)";
contact
"WG Web: <https://tools.ietf.org/wg/netmod/>
WG List: <mailto:netmod@ietf.org>
Author: Christian Hopps
<mailto:chopps@chopps.org>";
// RFC Ed.: replace XXXX with actual RFC number and
// remove this note.
description
"This module defines the configuration and operational state for
managing the IS-IS reverse metric functionality [RFC8500].
Copyright (c) 2019 IETF Trust and the persons identified as
authors of the code. All rights reserved.
Redistribution and use in source and binary forms, with or
without modification, is permitted pursuant to, and subject to
the license terms contained in, the Simplified BSD License set
forth in Section 4.c of the IETF Trust's Legal Provisions
Relating to IETF Documents
(https://trustee.ietf.org/license-info).
This version of this YANG module is part of RFC XXXX
(https://tools.ietf.org/html/rfcXXXX); see the RFC itself for
full legal notices.";
revision 2019-03-31 {
description "Initial Revision";
reference "RFC XXXX: YANG IS-IS Reverse Metric";
}
grouping reverse-metric-data {
description "IS-IS reverse metric data.";
container reverse-metric {
description "IS-IS reverse metric data.";
leaf metric {
type isis:wide-metric;
description "The reverse metric value.";
}
leaf flags {
type bits {
bit whole-lan {
position 0;
description
"The 'whole LAN' or W-bit. If true then a DIS
processing this reverse metric will add the metric
value to all the nodes it advertises in the
pseudo-node LSP for this interface. Otherwise it will
only increment the metric for the advertising node in
the pseudo-node LSP for this interface.";
}
bit allow-unreachable {
position 1;
description
"The 'allow-unreachable' or U-bit. If true it allows
the neighbor to increment the overall metric up to
2^24-1 rather than the lesser maximum of 2^24-2, and
if done will cause traffic to stop using rather than
avoid using the interface.";
}
}
description "The reverse metric flag values.";
}
}
}
grouping tlv16-reverse-metric {
description "IS-IS reverse metric TLV data.";
uses reverse-metric-data;
leaf te-metric {
type uint32;
description "The TE metric value from the sub-TLV if present.";
}
}
augment "/rt:routing/rt:control-plane-protocols/"
+"rt:control-plane-protocol/"
+"isis:isis/isis:interfaces/isis:interface" {
when "rt:type = 'isis:isis'" {
description
"This augment is only valid when routing protocol instance
type is 'isis'.";
}
description
"The reverse metric configuration for an interface.";
container reverse-metric {
description "Announce a reverse metric to neighbors.";
uses reverse-metric-data;
leaf exclude-te-metric {
type boolean;
default false;
description
"If true and there is a TE metric defined for this
interface then do not send the TE metric sub-TLV in the
reverse metric TLV.";
}
}
}
augment "/rt:routing/rt:control-plane-protocols/"
+"rt:control-plane-protocol/"
+"isis:isis/isis:interfaces/isis:interface/"
+"isis:adjacencies/isis:adjacency" {
when "rt:type = 'isis:isis'" {
description
"This augment is only valid when routing protocol instance
type is 'isis'";
}
description
"The reverse metric state advertised by a neighbor.";
uses tlv16-reverse-metric;
}
}
<CODE ENDS>
3. IANA Considerations
3.1. Updates to the IETF XML Registry
This document registers a URI in the "IETF XML Registry" [RFC3688].
Following the format in [RFC3688], the following registration has
been made:
URI urn:ietf:params:xml:ns:yang:ietf-isis-reverse-
metric
Registrant Contact The IESG.
XML N/A; the requested URI is an XML namespace.
3.2. Updates to the YANG Module Names Registry
This document registers one YANG module in the "YANG Module Names"
registry [RFC6020]. Following the format in [RFC6020], the following
registration has been made:
name ietf-isis-reverse-metric
namespace urn:ietf:params:xml:ns:yang:ietf-isis-reverse-metric
prefix isis-rmetric
reference RFC XXXX (RFC Ed.: replace XXX with actual RFC number and
remove this note.)
4. Security Considerations
The YANG module specified in this document defines a schema for data
that is designed to be accessed via network management protocols such
as NETCONF [RFC6241] or RESTCONF [RFC8040]. The lowest NETCONF layer
is the secure transport layer, and the mandatory-to-implement secure
transport is Secure Shell (SSH) [RFC6242]. The lowest RESTCONF layer
is HTTPS, and the mandatory-to-implement secure transport is TLS
[RFC8446].
The Network Configuration Access Control Model (NACM) [RFC8341]
provides the means to restrict access for particular NETCONF or
RESTCONF users to a preconfigured subset of all available NETCONF or
RESTCONF protocol operations and content.
The YANG module defined in this document can enable, disable and
modify the behavior of metrics used by routing. For the security
implications regarding these types of changes consult the [RFC8500]
which defines the functionality.
5. Normative References
[ISO10589] International Organization for Standardization,
"Intermediate system to intermediate system intra-domain-
routing routine information exchange protocol for use in
conjunction with the protocol for providing the
connectionless-mode Network Service (ISO 8473)",
ISO Standard 10589, 1992.
[RFC3688] Mealling, M., "The IETF XML Registry", BCP 81, RFC 3688,
DOI 10.17487/RFC3688, January 2004,
<https://www.rfc-editor.org/info/rfc3688>.
[RFC6020] Bjorklund, M., Ed., "YANG - A Data Modeling Language for
the Network Configuration Protocol (NETCONF)", RFC 6020,
DOI 10.17487/RFC6020, October 2010,
<https://www.rfc-editor.org/info/rfc6020>.
[RFC6241] Enns, R., Ed., Bjorklund, M., Ed., Schoenwaelder, J., Ed.,
and A. Bierman, Ed., "Network Configuration Protocol
(NETCONF)", RFC 6241, DOI 10.17487/RFC6241, June 2011,
<https://www.rfc-editor.org/info/rfc6241>.
[RFC6242] Wasserman, M., "Using the NETCONF Protocol over Secure
Shell (SSH)", RFC 6242, DOI 10.17487/RFC6242, June 2011,
<https://www.rfc-editor.org/info/rfc6242>.
[RFC8040] Bierman, A., Bjorklund, M., and K. Watsen, "RESTCONF
Protocol", RFC 8040, DOI 10.17487/RFC8040, January 2017,
<https://www.rfc-editor.org/info/rfc8040>.
[RFC8341] Bierman, A. and M. Bjorklund, "Network Configuration
Access Control Model", STD 91, RFC 8341,
DOI 10.17487/RFC8341, March 2018,
<https://www.rfc-editor.org/info/rfc8341>.
[RFC8342] Bjorklund, M., Schoenwaelder, J., Shafer, P., Watsen, K.,
and R. Wilton, "Network Management Datastore Architecture
(NMDA)", RFC 8342, DOI 10.17487/RFC8342, March 2018,
<https://www.rfc-editor.org/info/rfc8342>.
[RFC8446] Rescorla, E., "The Transport Layer Security (TLS) Protocol
Version 1.3", RFC 8446, DOI 10.17487/RFC8446, August 2018,
<https://www.rfc-editor.org/info/rfc8446>.
[RFC8500] Shen, N., Amante, S., and M. Abrahamsson, "IS-IS Routing
with Reverse Metric", RFC 8500, DOI 10.17487/RFC8500,
February 2019, <https://www.rfc-editor.org/info/rfc8500>.
6. Informative References
[RFC8340] Bjorklund, M. and L. Berger, Ed., "YANG Tree Diagrams",
BCP 215, RFC 8340, DOI 10.17487/RFC8340, March 2018,
<https://www.rfc-editor.org/info/rfc8340>.
Author's Address
Christian Hopps
LabN Consulting, L.L.C.
Email: chopps@chopps.org