BGP-LS Extensions for Advertising Path MTU

Document Type Replaced Internet-Draft (individual)
Authors Yongqing Zhu  , Zhibo Hu , Gang Yan  , Junda Yao 
Last updated 2018-06-30
Replaced by draft-zhu-idr-bgp-ls-path-mtu
Stream (None)
Intended RFC status (None)
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-zhu-idr-bgp-ls-path-mtu
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


BGP Link State (BGP-LS) describes a mechanism by which link-state and TE information can be collected from networks and shared with external components using the BGP routing protocol. The centralized controller (PCE/SDN) completes the service path calculation based on the information transmitted by the BGP-LS and delivers the result to the Path Computation Client (PCC) through the PCEP protocol. Segment Routing (SR) leverages the source routing paradigm, which can be directly applied to the MPLS architecture with no change on the forwarding plane and applied to the IPv6 architecture, with a new type of routing header, called SRH. The SR uses the IGP protocol as the control protocol. Compared to the MPLS tunneling technology, the SR does not require signaling. Therefore, the SR does not support the negotiation of the Path MTU. Since Multiple labels or SRv6 SIDs are pushed in the packets, it is more likely that the MTU exceeds the limit in the SR tunneling technology. This document specify the extension to BGP Link State (BGP-LS) to carry maximum transmission unit (MTU) messages. The PCE/SDN calculates the Path MTU while completing the service path calculation based on the information transmitted by the BGP-LS.


Yongqing Zhu (
Zhibo Hu (
Gang Yan (
Junda Yao (

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)