Quic Timestamps For Measuring One-Way Delays
draft-huitema-quic-ts-00
The information below is for an old version of the document.
| Document | Type | Active Internet-Draft (individual) | |
|---|---|---|---|
| Author | Christian Huitema | ||
| Last updated | 2020-02-24 | ||
| Stream | (None) | ||
| Formats | plain text xml htmlized pdfized bibtex | ||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | I-D Exists | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
draft-huitema-quic-ts-00
Network Working Group C. Huitema
Internet-Draft Private Octopus Inc.
Intended status: Experimental February 24, 2020
Expires: August 27, 2020
Quic Timestamps For Measuring One-Way Delays
draft-huitema-quic-ts-00
Abstract
The TimeStamp frame can be added to Quic packets when one way delay
measurements is useful. The timestamp is set to the number of
microseconds from the beginning of the connection to the time at
which the packet is sent. The draft defines the "enable_time_stamp"
transport parameter for negotiating the use of this extension frame,
and a new frame types for the time_stamped frame.
Status of This Memo
This Internet-Draft is submitted in full conformance with the
provisions of BCP 78 and BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF). Note that other groups may also distribute
working documents as Internet-Drafts. The list of current Internet-
Drafts is at https://datatracker.ietf.org/drafts/current/.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
This Internet-Draft will expire on August 27, 2020.
Copyright Notice
Copyright (c) 2020 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(https://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
Huitema Expires August 27, 2020 [Page 1]
Internet-Draft QUIC-TS February 2020
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Table of Contents
1. Measuring One-Way Delays . . . . . . . . . . . . . . . . . . 2
1.1. Terms and Definitions . . . . . . . . . . . . . . . . . . 3
2. Specification . . . . . . . . . . . . . . . . . . . . . . . . 3
2.1. Negotiation . . . . . . . . . . . . . . . . . . . . . . . 3
3. Time Stamp frame format . . . . . . . . . . . . . . . . . . . 3
3.1. RTT Measurements . . . . . . . . . . . . . . . . . . . . 4
3.2. One-Way Delay Measurements . . . . . . . . . . . . . . . 4
4. Discussion . . . . . . . . . . . . . . . . . . . . . . . . . 5
5. Security Considerations . . . . . . . . . . . . . . . . . . . 5
6. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 5
7. References . . . . . . . . . . . . . . . . . . . . . . . . . 6
7.1. Normative References . . . . . . . . . . . . . . . . . . 6
7.2. Informative References . . . . . . . . . . . . . . . . . 6
Author's Address . . . . . . . . . . . . . . . . . . . . . . . . 6
1. Measuring One-Way Delays
The QUIC Transport Protocol [I-D.ietf-quic-transport] provides a
secure, multiplexed connection for transmitting reliable streams of
application data. The algorithms for QUIC Loss Detection and
Congestion Control [I-D.ietf-quic-recovery] use measurement of Round
Trip Time (RTT) to determine when packets should be retransmitted.
RTT measurements are useful, but there are however many cases in
which more precise One-Way Delay (1WD) measurements enable more
efficient Loss Detection and Congestion Control.
An example would be the Low Extra Delay Background Transport (LEDBAT)
[RFC6817] which uses variations in transmission delay to detect
competition for transmission resource. Experience shows that while
LEDBAT may be implemented using RTT measurements, it is somewhat
inefficient because it will cause unnecessary slowdowns in case of
queues or delayed ACKs on the return path. Using 1WD solves these
issues. Similar argument can be made for most delay-based
algorithms.
We propose to enable one way delay measurements in QUIC by defining a
time_stamp frame carrying the time at which a packet is sent. The
use of this extension frame is negotiated with a transport parameter,
"enable_time_stamp". When the extension is negotiated by both
parties, this frame can be used in conjunction with other such as ACK
to measure one way delays.
Huitema Expires August 27, 2020 [Page 2]
Internet-Draft QUIC-TS February 2020
1.1. Terms and Definitions
The keywords "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and
"OPTIONAL" in this document are to be interpreted as described in BCP
14 [RFC2119] [RFC8174] when, and only when, they appear in all
capitals, as shown here.
2. Specification
The enable_time_stamp transport parameter used for negotiating the
use of the extension frame is defined in Section 2.1. The time_stamp
frame format is defined in Section 3.
2.1. Negotiation
The use of the time_stamp frame extension is negotiated using a
transport parameter:
o enable_time_stamp (TBD)
The enable time stamp transport parameter is included if the endpoint
accepts and sends time_stamp frames for this connection. This
parameter has a zero-length value. Negotiation is successful if both
peers support include this parameter in their transport parameter
message. Peers that receive a time_stamp frame in the absence of
successful negotiation MAY terminate the connection with a PROTOCOL
VIOLATION error.
If negotiation is successful the peers SHOULD add a time_stamp frame
to packets carrying an ACK frame.
3. Time Stamp frame format
Timestamped ACK are identified by the frame type:
o time_stamp (TBD)
Time stamp frames carry a single parameter, the time stamp.
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Time Stamp (i) ...
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Figure 1: ACK Frame Format with Time Stamp
Huitema Expires August 27, 2020 [Page 3]
Internet-Draft QUIC-TS February 2020
The time stamp encodes the number of microseconds since the beginning
of the connection, as measured by the peer at the time at which the
packet is sent. It is encoded using the exponent selected by the
peer in the ack_delay_exponent. The exponent reduced time stamp is
encoded as a variable length integer.
3.1. RTT Measurements
RTT measurements are performed as specified in Section 4 of
[I-D.ietf-quic-recovery], without reference to the Timestamp
parameter of the Timestamped ACK frames.
3.2. One-Way Delay Measurements
An endpoint generates a One Way Delay Sample on receiving a packet
containing both a Time Stamp frame and an ACK frame that meets the
following two conditions:
o the largest acknowledged packet number is newly acknowledged, and
o at least one of the newly acknowledged packets was ack-eliciting.
The One Way Delay sample, latest_1wd, is generated as the time
elapsed since the largest acknowledged packet was sent, corrected for
the difference between local time at the sending peer and connection
time at the receiving peer, phase_shift.
latest_1wd = time_stamp - send_time_of_largest_acked - phase_shift
By convention, the phase_shift is estimated upon reception of the
first RTT sample, first_rtt. It is set to:
phase_shift = time_stamp - send_time_of_largest_acked - latest_rtt/2
In that formula, we assume that the local time are measured in
microseconds since the beginning of the connection.
We understand that clocks may drift over time, and that simply
estimating a phase shift at the beginning of a connection may be too
simplistic for long duration connections. Implementations MAY adopt
different strategies to reestimate the phase shift at appropriate
intervals. Specifying these strategies is beyond the scope of this
document.
Huitema Expires August 27, 2020 [Page 4]
Internet-Draft QUIC-TS February 2020
4. Discussion
This document replaces an earlier proposal to modify the format of
the ACK frame by including a time stamp inside the modified frame.
The revised proposal encodes the time stamp independently of the ACK
frame, which requires slightly more overhead to encode the type of
the time stamp frame.
Defining an independent frame allows for more flexibility. This
draft defines the combination of time stamp with ACK frames, but they
could be combined with other frames as well. For example, adding a
time stamp to packets carrying a Path Response could allow measuring
one way delays before deciding to migrate to a new path.
5. Security Considerations
The Timestamp value in the Time Stamp frame is asserted by the sender
of the packet. Adversarial peers could chose values of the time
stamp designed to exercise side effects in congestion control
algorithms or other algorithms relying on the one-way delays. This
can be mitigated by running plausibility checks on the received
values. For example, each peer can maintain statistics not just on
the One Way Delays, but also on the differences between One Way
Delays and RTT, and detect outlier values. Peers can also compare
the differences between timestamps in packets carrying
acknowledgements and the differences between the sending times of
corresponding packets, and detect anomalies if the delays between
acknowledging packets appears shorter than the delays when sending
them.
6. IANA Considerations
This document registers a new value in the QUIC Transport Parameter
Registry:
Value: TBD (using value 0x7157 in early deployments)
Parameter Name: enable_time_stamp
Specification: Indicates that the connection should use TimeStamped
ACK frames
This document also registers a new value in the QUIC Frame Type
registry:
Value: TBD (using value 757 in early deployments)
Frame Name: Time Stamp
Huitema Expires August 27, 2020 [Page 5]
Internet-Draft QUIC-TS February 2020
Specification: time stamp at the time packet was sent
7. References
7.1. Normative References
[I-D.ietf-quic-recovery]
Iyengar, J. and I. Swett, "QUIC Loss Detection and
Congestion Control", draft-ietf-quic-recovery-26 (work in
progress), February 2020.
[I-D.ietf-quic-transport]
Iyengar, J. and M. Thomson, "QUIC: A UDP-Based Multiplexed
and Secure Transport", draft-ietf-quic-transport-27 (work
in progress), February 2020.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119,
DOI 10.17487/RFC2119, March 1997,
<https://www.rfc-editor.org/info/rfc2119>.
[RFC8174] Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC
2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174,
May 2017, <https://www.rfc-editor.org/info/rfc8174>.
7.2. Informative References
[RFC6817] Shalunov, S., Hazel, G., Iyengar, J., and M. Kuehlewind,
"Low Extra Delay Background Transport (LEDBAT)", RFC 6817,
DOI 10.17487/RFC6817, December 2012,
<https://www.rfc-editor.org/info/rfc6817>.
Author's Address
Christian Huitema
Private Octopus Inc.
427 Golfcourse Rd
Friday Harbor WA 98250
U.S.A
Email: huitema@huitema.net
Huitema Expires August 27, 2020 [Page 6]