IPv6 Multicast Address Scopes
draft-ietf-6man-multicast-scopes-00

The information below is for an old version of the document
Document Type Active Internet-Draft (6man WG)
Last updated 2013-08-20
Stream IETF
Intended RFC status (None)
Formats plain text pdf html bibtex
Stream WG state WG Document
Document shepherd None
IESG IESG state I-D Exists
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)
Internet Engineering Task Force                                 R. Droms
Internet-Draft                                                     Cisco
Updates: RFC 4291 (if approved)                          August 20, 2013
Intended status: Standards Track
Expires: February 21, 2014

                     IPv6 Multicast Address Scopes
                draft-ietf-6man-multicast-scopes-00.txt

Abstract

   This document updates the definitions of IPv6 multicast scopes.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on February 21, 2014.

Copyright Notice

   Copyright (c) 2013 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

1.  Definition of IPv6 Multicast Address Scopes

Droms                   Expires February 21, 2014               [Page 1]
Internet-Draft        IPv6 Multicast Address Scopes          August 2013

   RFC 4291 [RFC4291] defines "scop is a 4-bit multicast scope value
   used to limit the scope of the multicast group." scop 3 is defined as
   "reserved" in RFC 4291.  The multicast protocol specification in
   draft-ietf-roll-trickle-mcast [I-D.ietf-roll-trickle-mcast] desires
   to use multicast scop 3 for transport of multicast traffic scoped to
   a RPL realm (or "domain") [RFC6550].  The use of this scop value is
   to accommodate a multicast scope that is greater than Link-Local but
   is also automatically determined by the network architecture; for
   example, all of the hosts and routers in a multi-link subnet RPL
   realm.

   The following table updates the definitions in RFC 4291:

   0  reserved

   1  Interface-Local scope

   2  Link-Local scope

   3  Realm-Local scope

   4  Admin-Local scope

   5  Site-Local scope

   6  (unassigned)

   7  (unassigned)

   8  Organization-Local scope

   9  (unassigned)

   A  (unassigned)

   B  (unassigned)

   C  (unassigned)

   D  (unassigned)

   E  Global scope

   F  reserved

   The following paragraph is added as the third paragraph following the
   list of scop values in RFC 4291:

Droms                   Expires February 21, 2014               [Page 2]
Internet-Draft        IPv6 Multicast Address Scopes          August 2013

         Realm-Local scope is the largest scope that is automatically
         configured, i.e., automatically derived from physical
         connectivity or other, non-multicast-related configuration.
         According to <xref target="RFC4007">RFC&nbsp;4007</xref>, the
         zone of a Realm-Local scope must fall within zones of larger
         scope.  Because the zone of a Realm-Local scope is configured
         automatically, while the zones of larger scopes are configured
         manually, care must be taken in the definition of those larger
         scopes to ensure that inclusion contraint is met.

2.  Definition of Realm-Local scopes

   The definition of any Realm-Local scope for a particular network
   technology should be published in an RFC.  For example, such a scope
   definition would be appropriate for publication in an "IPv6-over-foo"
   RFC.

   Any RFCs that include the definition of a Realm-Local scope will be
   listed in the IANA "IPv6 Multicast Address Scopes" registry.

3.  IANA Considerations

   IANA is asked to establish a sub-registry titled "IPv6 Multicast
   Address Scopes" in the existing "Internet Protocol version 6 (IPv6)
   Multicast Address Allocations" registry.  The "IPv6 Multicast Address
   Scopes" is to be populated with the scope values given in section 1,
   with a note associated with scope 3 listing all RFCs that define
   Realm-Local scoping rules that use scope 3.

4.  Security Considerations

   This document has no security considerations beyond those in RFC 4291
   [RFC4291].

5.  References

5.1.  Normative References
Show full document text