A PIE-Based AQM for DOCSIS Cable Modems
draft-ietf-aqm-docsis-pie-02

Document Type Active Internet-Draft (aqm WG)
Last updated 2016-12-13 (latest revision 2016-02-15)
Replaces draft-white-aqm-docsis-pie
Stream IETF
Intended RFC status Informational
Formats plain text xml pdf html bibtex
Reviews
Stream WG state Submitted to IESG for Publication
Document shepherd Wesley Eddy
Shepherd write-up Show (last changed 2016-02-16)
IESG IESG state RFC Ed Queue
Consensus Boilerplate Yes
Telechat date
Responsible AD Martin Stiemerling
Send notices to "Wesley Eddy" <wes@mti-systems.com>
IANA IANA review state IANA OK - No Actions Needed
IANA action state No IC
RFC Editor RFC Editor state AUTH48
Active Queue Management and Packet Scheduling (aqm)             G. White
Internet-Draft                                                 CableLabs
Intended status: Informational                                    R. Pan
Expires: August 15, 2016                                   Cisco Systems
                                                       February 12, 2016

                A PIE-Based AQM for DOCSIS Cable Modems
                      draft-ietf-aqm-docsis-pie-02

Abstract

   Cable modems based on the DOCSIS(R) specification provide broadband
   Internet access to over one hundred million users worldwide.  In some
   cases, the cable modem connection is the bottleneck (lowest speed)
   link between the customer and the Internet.  As a result, the impact
   of buffering and bufferbloat in the cable modem can have a
   significant effect on user experience.  The CableLabs DOCSIS 3.1
   specification introduces requirements for cable modems to support an
   Active Queue Management (AQM) algorithm that is intended to alleviate
   the impact that buffering has on latency sensitive traffic, while
   preserving bulk throughput performance.  In addition, the CableLabs
   DOCSIS 3.0 specifications have also been amended to contain similar
   requirements.  This document describes the requirements on Active
   Queue Management that apply to DOCSIS equipment, including a
   description of the "DOCSIS-PIE" algorithm that is required on DOCSIS
   3.1 cable modems.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on August 15, 2016.

White & Pan              Expires August 15, 2016                [Page 1]
Internet-Draft                 docsis-pie                  February 2016

Copyright Notice

   Copyright (c) 2016 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
   2.  Overview of DOCSIS AQM Requirements . . . . . . . . . . . . .   3
   3.  The DOCSIS MAC Layer and Service Flows  . . . . . . . . . . .   3
   4.  DOCSIS-PIE vs. PIE  . . . . . . . . . . . . . . . . . . . . .   5
     4.1.  Latency Target  . . . . . . . . . . . . . . . . . . . . .   5
     4.2.  Departure rate estimation . . . . . . . . . . . . . . . .   5
     4.3.  Enhanced burst protection . . . . . . . . . . . . . . . .   6
     4.4.  Expanded auto-tuning range  . . . . . . . . . . . . . . .   7
     4.5.  Trigger for exponential decay . . . . . . . . . . . . . .   7
     4.6.  Drop probability scaling  . . . . . . . . . . . . . . . .   7
     4.7.  Support for explicit congestion notification  . . . . . .   8
   5.  Implementation Guidance . . . . . . . . . . . . . . . . . . .   8
   6.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   8
   7.  Security Considerations . . . . . . . . . . . . . . . . . . .   9
   8.  Informative References  . . . . . . . . . . . . . . . . . . .   9
   Appendix A.  DOCSIS-PIE Algorithm definition  . . . . . . . . . .   9
     A.1.  DOCSIS-PIE AQM Constants and Variables  . . . . . . . . .  10
       A.1.1.  Configuration parameters  . . . . . . . . . . . . . .  10
       A.1.2.  Constant values . . . . . . . . . . . . . . . . . . .  10
       A.1.3.  Variables . . . . . . . . . . . . . . . . . . . . . .  10
       A.1.4.  Public/system functions:  . . . . . . . . . . . . . .  11
     A.2.  DOCSIS-PIE AQM Control Path . . . . . . . . . . . . . . .  11
     A.3.  DOCSIS-PIE AQM Data Path  . . . . . . . . . . . . . . . .  13
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . .  15
Show full document text