RTP Payload Format for MIDI
draft-ietf-avt-mwpp-midi-rtp-08
| Document | Type |
Expired Internet-Draft
(avt WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | John Lazzaro , John Wawrzynek | ||
| Last updated | 2003-07-01 | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo describes an RTP payload format for the MIDI command language. The format encodes all commands that may legally appear on a MIDI 1.0 DIN cable. The format is suitable for interactive applications (such as the remote operation of musical instruments) and content-delivery applications (such as file streaming). The format may be used over unicast and multicast UDP as well as TCP, and defines tools for graceful recovery from packet loss. Stream behavior, including the MIDI rendering method, may be customized during session setup. The format also serves as a mode for the mpeg4-generic format, to support the MPEG 4 Audio Object Types for General MIDI, Downloadable Sounds Level 2, and Structured Audio.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)