How to Write an RTP Payload Format
draft-ietf-avt-rtp-howto-06

Document Type Replaced Internet-Draft (avt WG)
Author Magnus Westerlund 
Last updated 2011-10-25 (latest revision 2009-03-02)
Replaces draft-westerlund-avt-rtp-howto
Replaced by RFC 8088
Stream Internet Engineering Task Force (IETF)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state Replaced by draft-ietf-payload-rtp-howto
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-avt-rtp-howto-06.txt

Abstract

This document contains information on how to best write an RTP payload format. Reading tips, design practices, and practical tips on how to quickly and with good results produce an RTP payload format specification. A template is also included with instructions that can be used when writing an RTP payload format.

Authors

Magnus Westerlund (magnus.westerlund@ericsson.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)