How to Write an RTP Payload Format
draft-ietf-avt-rtp-howto-06
| Document | Type |
Replaced Internet-Draft
(avt WG)
Expired & archived
|
|
|---|---|---|---|
| Author | Magnus Westerlund | ||
| Last updated | 2011-10-25 (Latest revision 2009-03-02) | ||
| Replaces | draft-westerlund-avt-rtp-howto | ||
| Replaced by | draft-ietf-payload-rtp-howto | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-payload-rtp-howto | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document contains information on how to best write an RTP payload format. Reading tips, design practices, and practical tips on how to quickly and with good results produce an RTP payload format specification. A template is also included with instructions that can be used when writing an RTP payload format.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)