Layer 2 Relay Agent Information
draft-ietf-dhc-l2ra-06
Document | Type |
Expired Internet-Draft
(dhc WG)
Expired & archived
|
|
---|---|---|---|
Authors | Bharat Joshi , Pavan Kurapati | ||
Last updated | 2012-07-30 (Latest revision 2012-01-25) | ||
Replaces | draft-joshi-dhc-l2ra | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Expired | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
In some networks, DHCP servers rely on Relay Agent Information option appended by Relay Agents for IP address and other parameter assignment policies. This works fine when end hosts are directly connected to Relay Agents. In some network configurations, one or more Layer 2 devices may reside between DHCP clients and Relay agent. In these network scenarios, it is difficult to use the Relay Agent Information option for IP address and other parameter assignment policies effectively. So there is a need for the device that is closest to the end hosts to append a Relay Agent Information option in DHCP messages. These devices are typically known as Layer 2 Relay Agents. This document aims to describe the network scenarios where a Layer 2 Relay Agent is in use and also how it handles DHCP messages.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)