Diameter Overload Rate Control
draft-ietf-dime-doic-rate-control-02

The information below is for an old version of the document
Document Type Expired Internet-Draft (dime WG)
Last updated 2016-03-03 (latest revision 2015-08-31)
Replaces draft-donovan-dime-doc-rate-control
Stream IETF
Intended RFC status Proposed Standard
Formats
Expired & archived
pdf htmlized bibtex
Reviews
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD Kathleen Moriarty
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-dime-doic-rate-control-02.txt

Abstract

This specification documents an extension to the Diameter Overload Indication Conveyance (DOIC) base solution. This extension adds a new overload control abatement algorithm. This abatement algorithm allows for a DOIC reporting node to specify a maximum rate at which a DOIC reacting node sends Diameter requests to the DOIC reporting node. Requirements

Authors

Steve Donovan (srdonovan@usdonovans.com)
Eric Noel (ecnoel@research.att.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)