Skip to main content

A Method for Generating Link-Scoped IPv6 Multicast Addresses
RFC 4489

Document Type RFC - Proposed Standard (April 2006)
Updates RFC 3306
Authors Myung-Ki Shin , Hyoung-Jun Kim , Park Jung-Soo
Last updated 2015-10-14
RFC stream Internet Engineering Task Force (IETF)
Formats
Additional resources Mailing list discussion
IESG Responsible AD Margaret Cullen
Send notices to (None)
RFC 4489
Network Working Group                                          J-S. Park
Request for Comments: 4489                                     M-K. Shin
Updates: 3306                                                   H-J. Kim
Category: Standards Track                                           ETRI
                                                              April 2006

      A Method for Generating Link-Scoped IPv6 Multicast Addresses

Status of This Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2006).

Abstract

   This document specifies an extension to the multicast addressing
   architecture of the IPv6 protocol.  The extension allows the use of
   Interface Identifiers (IIDs) to allocate multicast addresses.  When a
   link-local unicast address is configured at each interface of a node,
   an IID is uniquely determined.  After that, each node can generate
   its unique multicast addresses automatically without conflicts.  The
   alternative method for creating link-local multicast addresses
   proposed in this document is better than known methods like unicast-
   prefix-based IPv6 multicast addresses.  This memo updates RFC 3306.

Table of Contents:

   1. Introduction ....................................................2
   2. Applicability ...................................................2
   3. Link-Scoped Multicast Address Format ............................3
   4. Example .........................................................3
   5. Consideration of Lifetime .......................................4
   6. Security Considerations .........................................4
   7. Acknowledgements ................................................4
   8. References ......................................................5

Park, et al.                Standards Track                     [Page 1]
RFC 4489               Link-Scoped IPv6 Multicast             April 2006

1.  Introduction

   This document defines an extension to the multicast portion of the
   IPv6 addressing architecture [RFC4291].  The current architecture
   does not contain any built-in support for dynamic address allocation.
   The extension allows for use of IIDs to allocate multicast addresses.
   When a link-local unicast address is configured at each interface of
   a node, an IID is uniquely determined.  After that, each node can
   generate its unique multicast addresses automatically without
   conflicts.  That is, these addresses could safely be configured at
   any time after Duplicate Address Detection (DAD) has completed.

   This method for the link-local scope is preferred over unicast-
   prefix-based IPv6 multicast addresses [RFC3306], since by delegating
   multicast addresses using the IID, each node can generate its
   multicast addresses automatically without allocation servers.  This
   method works better than the unicast-prefix-based method with
   applications in serverless environments such as ad-hoc and network
   mobility.  This document restricts the usage of defined fields such
   as the scop, plen, and network prefix fields of [RFC3306].
   Therefore, this document specifies encoded information for link-local
   scope in multicast addresses.

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].

2.  Applicability

   The allocation technique in this document is designed to be used in
   any environment in which link-local scope IPv6 multicast addresses
   are assigned or selected.  This method goes especially well with
   nodes supplying multicast services in a zeroconf/serverless
   environment.  For example, multicast addresses less than or equal to
   link-local scope are themselves generated by nodes supplying
   multicast services without conflicts.  Also, hosts that are supplied
   multicast services from multicast servers then make multicast
   addresses of multicast servers using ND (address resolution) and
   well-known group IDs [RFC2461].

   Consequently, this technique MUST only be used for link scoped
   multicast addresses.  If you want to use multicast addresses greater
   than link-local scope, you need to use other methods as described in
   [RFC3306].

Park, et al.                Standards Track                     [Page 2]
RFC 4489               Link-Scoped IPv6 Multicast             April 2006

3.  Link-Scoped Multicast Address Format

   This document specifies a new format that incorporates IID in the
   link-local scope multicast addresses.

   Figure 1 illustrates the new format for link-scoped multicast
   addresses.

      |   8    |  4 |  4 |   8    |    8   |       64       |    32    |
      +--------+----+----+--------+--------+----------------+----------+
      |11111111|flgs|scop|reserved|  plen  |       IID      | group ID |
      +--------+----+----+--------+--------+----------------+----------+

           Figure 1.  Link-Scoped Multicast IPv6 Address Format

   The flgs, scop, and plen fields are used to identify whether an
   address is a multicast address, as follows:

    1. flgs MUST be "0011".

    2. scop MUST be <= 2.

    3. The reserved field MUST be zero.

    4. The "plen" field is a special value, "1111 1111" (decimal 255).

   The IID field (replacing the 64-bit prefix field from [RFC3306]) is
   used to distinguish each node from others.  Given the use of this
   method for link-local scope, the IID embedded in the multicast
   address MUST only come from the IID of the link-local unicast address
   on the interface after DAD has completed.  That is, the creation of
   the multicast address MUST only occur after DAD has completed as part
   of the auto-configuration process.

   Group ID is generated to indicate a multicast application and is used
   to guarantee its uniqueness only in the host.  It may also be set on
   the basis of the guidelines outlined in [RFC3307].

4.  Example

   In an Ethernet environment, if the link-local unicast address is
   FE80::A12:34FF:FE56:7890, the link-scoped multicast prefix of the
   node is FF32:00FF:A12:34FF:FE56:7890::/96.

Park, et al.                Standards Track                     [Page 3]
RFC 4489               Link-Scoped IPv6 Multicast             April 2006

5.  Consideration of Lifetime

   Generally, link-scoped multicast addresses have no lifetime, because
   link-local unicast addresses also have no lifetime.  However, this is
   not true in the mobile environment.  Even though multicast addresses
   are created from the unique IIDs of unicast addresses, their useful
   lifetime is linked to the period during which the IID is known to be
   unique.  Thus, conflict is possible between IIDs, due to a new node
   in merged network that uses the same IID as a powered node.

   In this scenario, DAD also fails to guarantee uniqueness of the
   unicast address, but this document does not try to address this
   issue.

6.  Security Considerations

   The uniqueness of multicast addresses using this method is guaranteed
   by the DAD process.  So, a secure DAD process is needed for stability
   of this method.  This document proposes the mechanism in [RFC3041]
   for this purpose.

   [RFC3041] describes the privacy extension to IPv6 stateless address
   autoconfiguration to configure the IID of non-link-local scope
   unicast addresses.  [RFC3041] cannot be used for making a link-local
   unicast address, and hence it cannot be used to create an IID for
   link-scoped multicast address.  However, as [RFC3041] does not
   protect the privacy of link-local unicast addresses, it does not seem
   to be required to protect the privacy of IID-based link-local
   multicast addresses.

7.  Acknowledgements

   We would like to thank Dave Thaler and Brian Haberman for their
   comments related to the consistency between the unicast prefix-based
   multicast document and this one.  Special thanks are due to Erik
   Nordmark and Pekka Savola for valuable comments.

Park, et al.                Standards Track                     [Page 4]
RFC 4489               Link-Scoped IPv6 Multicast             April 2006

8.  References

8.1.  Normative References

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119, March 1997.

   [RFC2461]  Narten, T., Nordmark, E., and W. Simpson, "Neighbor
              Discovery for IP Version 6 (IPv6)", RFC 2461, December
              1998..ti  3

   [RFC3041]  Narten, T. and R. Draves, "Privacy Extensions for
              Stateless Address Autoconfiguration in IPv6", RFC 3041,
              January 2001.

   [RFC3306]  Haberman, B. and D. Thaler, "Unicast-Prefix-based IPv6
              Multicast Addresses", RFC 3306, August 2002.

   [RFC3307]  Haberman, B., "Allocation Guidelines for IPv6 Multicast
              Addresses", RFC 3307, August 2002.

   [RFC4291]  Hinden, R. and S. Deering, "IP Version 6 Addressing
              Architecture", RFC 4291, February 2006.

Authors' Addresses

   Jung-Soo Park
   ETRI PEC
   161 Gajeong-Dong, Yuseong-Gu, Daejeon 305-350, Korea

   Phone: +82 42 860 6514
   EMail: pjs@etri.re.kr

   Myung-Ki Shin
   ETRI PEC
   161 Gajeong-Dong, Yuseong-Gu, Daejeon 305-350, Korea

   Phone: +82 42 860 4847
   EMail: myungki.shin@gmail.com

   Hyoung-Jun Kim
   ETRI PEC
   161 Gajeong-Dong, Yuseong-Gu, Daejeon 305-350, Korea

   Phone: +82 42 860 6576
   EMail: khj@etri.re.kr

Park, et al.                Standards Track                     [Page 5]
RFC 4489               Link-Scoped IPv6 Multicast             April 2006

Full Copyright Statement

   Copyright (C) The Internet Society (2006).

   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at ietf-
   ipr@ietf.org.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.

Park, et al.                Standards Track                     [Page 6]