Skip to main content

Megaco/H.248 NAS Package
draft-ietf-megaco-naspkg-04

Document Type Expired Internet-Draft (megaco WG)
Expired & archived
Authors Alan V. Whitton , Julian Mitchell , Ravi Subramaniam , Tom Taylor
Last updated 2015-10-14 (Latest revision 2002-04-09)
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status (None)
Formats
Additional resources Mailing list discussion
Stream WG state WG Document
Document shepherd (None)
IESG IESG state Expired (IESG: Dead)
Action Holders
(None)
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD Jon Peterson
IESG note
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document is intended to satisfy the requirements in section 11.2.5 of the Megaco/H.248 requirements document. It defines five packages: - the base NAS package contains properties and events supported by all NAS terminations; - the NAS Incoming package contains properties and events supported by NAS terminations involved in calls initiated by the circuit network; - the NAS Outgoing package contains properties supported by NAS terminations involved in calls outgoing to the circuit network; - the NAS Control package contains an event supported by a NAS Control termination, which allows the MG to indicate a request to initiate a data connection to a terminal served by the switched circuit network; - the NAS ROOT package contains properties supported by an MG which is also capable of supporting at least the NAS and NAS Incoming packages.

Authors

Alan V. Whitton
Julian Mitchell
Ravi Subramaniam
Tom Taylor

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)