Megaco/H.248 NAS Package
draft-ietf-megaco-naspkg-04
| Document | Type |
Expired Internet-Draft
(megaco WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | Alan V. Whitton , Julian Mitchell , Ravi Subramaniam , Tom Taylor | ||
| Last updated | 2015-10-14 (Latest revision 2002-04-09) | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Expired (IESG: Dead) | |
| Action Holders |
(None)
|
||
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | Jon Peterson | ||
| IESG note | |||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document is intended to satisfy the requirements in section 11.2.5 of the Megaco/H.248 requirements document. It defines five packages: - the base NAS package contains properties and events supported by all NAS terminations; - the NAS Incoming package contains properties and events supported by NAS terminations involved in calls initiated by the circuit network; - the NAS Outgoing package contains properties supported by NAS terminations involved in calls outgoing to the circuit network; - the NAS Control package contains an event supported by a NAS Control termination, which allows the MG to indicate a request to initiate a data connection to a terminal served by the switched circuit network; - the NAS ROOT package contains properties supported by an MG which is also capable of supporting at least the NAS and NAS Incoming packages.
Authors
Alan V. Whitton
Julian Mitchell
Ravi Subramaniam
Tom Taylor
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)