Skip to main content

Multiprotocol Label Switching (MPLS) Traffic Engineering Management Information Base for Fast Reroute
draft-ietf-mpls-fastreroute-mib-21

Yes

(Adrian Farrel)

No Objection

(Dan Romascanu)
(David Harrington)
(Gonzalo Camarillo)
(Jari Arkko)
(Peter Saint-Andre)
(Ralph Droms)
(Robert Sparks)
(Ron Bonica)
(Russ Housley)
(Tim Polk)

Note: This ballot was opened for revision 21 and is now closed.

Adrian Farrel Former IESG member
Yes
Yes () Unknown

                            
Dan Romascanu Former IESG member
(was Discuss) No Objection
No Objection (2011-05-05) Unknown

                            
David Harrington Former IESG member
(was Discuss) No Objection
No Objection (2011-06-02) Unknown

                            
Gonzalo Camarillo Former IESG member
No Objection
No Objection () Unknown

                            
Jari Arkko Former IESG member
No Objection
No Objection () Unknown

                            
Peter Saint-Andre Former IESG member
No Objection
No Objection () Unknown

                            
Ralph Droms Former IESG member
No Objection
No Objection () Unknown

                            
Robert Sparks Former IESG member
No Objection
No Objection () Unknown

                            
Ron Bonica Former IESG member
No Objection
No Objection () Unknown

                            
Russ Housley Former IESG member
No Objection
No Objection () Unknown

                            
Sean Turner Former IESG member
No Objection
No Objection (2010-12-14) Unknown
#1 Spell out first use of LSR. 

#2) On page 7:

a) Need "--" before mplsFrr...?

        -- The first value would be: 
                           mplsFrrOne2OneDetourActive.1.6553601


b) Need comma after "= 0" in the following?

    mplsFrrOne2OneDetourMergedDetourInst   = 0
      }
Stewart Bryant Former IESG member
(was Discuss) No Objection
No Objection (2010-12-13) Unknown
From the RtgArea review:

"The document defines three MIB modules but it only provides an example of how it could be used for the MPLS-FRR-ONE2ONE-STD-MIB. Personally I find examples of how to use MIBs extremely helpful when I have had to make use of a MIB for configuration or diagnostics. I would suggest adding examples of usage for the other two MIBs specified in the document."
Tim Polk Former IESG member
No Objection
No Objection () Unknown