LDP Downstream-on-Demand in Seamless MPLS

The information below is for an old version of the document
Document Type Expired Internet-Draft (mpls WG)
Last updated 2013-02-03 (latest revision 2012-08-02)
Replaces draft-beckhaus-ldp-dod
Stream IETF
Intended RFC status (None)
Expired & archived
plain text pdf html
Stream WG state WG Document
Document shepherd None
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


Seamless MPLS design enables a single IP/MPLS network to scale over core, metro and access parts of a large packet network infrastructure using standardized IP/MPLS protocols. One of the key goals of Seamless MPLS is to meet requirements specific to access, including high number of devices, their position in network topology and their compute and memory constraints that limit the amount of state access devices can hold.This can be achieved with LDP Downstream-on-Demand (LDP DoD) label advertisement. This document describes LDP DoD use cases and lists required LDP DoD procedures in the context of Seamless MPLS design. In addition, a new optional TLV type in the LDP label request message is defined for fast-up convergence.


(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)