MPLS Performance Measurement UDP Return Path
draft-ietf-mpls-pm-udp-return-00
| Document | Type | Replaced Internet-Draft (mpls WG) | |
|---|---|---|---|
| Authors | Stewart Bryant , Siva Sivabalan , Sagar Soni | ||
| Last updated | 2014-08-01 (latest revision 2014-07-29) | ||
| Replaces | draft-bryant-mpls-oam-udp-return | ||
| Replaced by | RFC 7876 | ||
| Stream | IETF | ||
| Intended RFC status | (None) | ||
| Formats |
Expired & archived
pdf
htmlized (tools)
htmlized
bibtex
|
||
| Stream | WG state | WG Document | |
| Document shepherd | Loa Andersson | ||
| IESG | IESG state | Replaced by draft-ietf-mpls-rfc6374-udp-return-path | |
| Consensus Boilerplate | Unknown | ||
| Telechat date | |||
| Responsible AD | (None) | ||
| Send notices to | (None) | ||
https://www.ietf.org/archive/id/draft-ietf-mpls-pm-udp-return-00.txt
Abstract
This document specifies the proceedure to be used by the Packet Loss and Delay Measurement for MPLS Networks protocol defined in RFC6374 when sending and processing MPLS performance management out-of-band responses for delay and loss measurements over an IP/UDP return path.
Authors
Stewart Bryant
(stbryant@cisco.com)
Siva Sivabalan
(msiva@cisco.com)
Sagar Soni
(sagsoni@cisco.com)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)