Seamless MPLS Architecture

The information below is for an old version of the document
Document Type Expired Internet-Draft (mpls WG)
Last updated 2013-04-25 (latest revision 2012-10-22)
Replaces draft-leymann-mpls-seamless-mpls
Stream IETF
Intended RFC status (None)
Expired & archived
plain text pdf html
Stream WG state WG Document
Document shepherd None
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This documents describes an architecture which can be used to extend MPLS networks to integrate access and aggregation networks into a single MPLS domain ("Seamless MPLS"). The Seamless MPLS approach is based on existing and well known protocols. It provides a highly flexible and a scalable architecture and the possibility to integrate 100.000 of nodes. The separation of the service and transport plane is one of the key elements; Seamless MPLS provides end to end service independent transport. Therefore it removes the need for service specific configurations in network transport nodes (without end to end transport MPLS, some additional services nodes/configurations would be required to glue each transport domain). This draft defines a routing architecture using existing standardized protocols. It does not invent any new protocols or defines extensions to existing protocols.


(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)