Skip to main content

A Simple Control Protocol for MPLS SFLs
draft-ietf-mpls-sfl-control-02

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Active".
Expired & archived
Authors Stewart Bryant , George Swallow , Siva Sivabalan
Last updated 2022-07-25 (Latest revision 2022-01-21)
Replaces draft-bryant-mpls-sfl-control
RFC stream Internet Engineering Task Force (IETF)
Formats
Reviews
Additional resources Mailing list discussion
Stream WG state Waiting for WG Chair Go-Ahead
Document shepherd Mach Chen
IESG IESG state Expired
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD (None)
Send notices to loa@pi.nu, mach.chen@huawei.com

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

In RFC 8957 the concept of MPLS synonymos flow labels (SFL) was introduced. This document describes a simple control protocol that runs over an associated control header to request, withdraw, and extend the lifetime of such labels. It is not the only control protocol that might be used to support SFL, but it has the benefit of being able to be used without modifying of the existing MPLS control protocols. The existence of this design is not intended to restrict the ability to enhance an existing MPLS control protocol to add a similar capability. A Querier MUST wait a configured time (suggested wait of 60 seconds) before re-attempting a Withdraw request. No more than three Withdraw requests SHOULD be made. These restrictions are to prevent overloading the control plane of the actioning router.

Authors

Stewart Bryant
George Swallow
Siva Sivabalan

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)