MPLS-TP 1toN Protection
draft-ietf-mpls-tp-1ton-protection-02
| Document | Type | Expired Internet-Draft (mpls WG) | |
|---|---|---|---|
| Authors | Eric Osborne , Fei Zhang , Yaacov Weingarten , Nurit Sprecher | ||
| Last updated | 2014-02-07 (Latest revision 2013-08-06) | ||
| Replaces | draft-ezy-mpls-tp-1ton-protection | ||
| Stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats |
Expired & archived
plain text
xml
htmlized
pdfized
bibtex
|
||
| Stream | WG state | Dead WG Document | |
| Document shepherd | Loa Andersson | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
https://www.ietf.org/archive/id/draft-ietf-mpls-tp-1ton-protection-02.txt
Abstract
There is a requirement for Multiprotocol Label Switching Transport Profile(MPLS-TP) to support 1:n linear protection for transport paths. This requirement is further elaborated in RFC6372 [SurvivFwk]. The basic protocol for linear protection, specified in RFC6378 [LinProt], is limited to 1+1 and 1:1 protection. This document extends that protocol to address the additional functionality necessary to support scenarios where a single protection path is preconfigured to provide protection of multiple transport paths between two joint endpoints. This document is a product of a joint Internet Engineering Task Force (IETF) / International Telecommunications Union Telecommunications Standardization Sector (ITU-T) effort to include an MPLS Transport Profile within the IETF MPLS and PWE3 architectures to support the capabilities and functionalities of a packet transport network as defined by the ITU-T.
Authors
Eric Osborne
Fei Zhang
Yaacov Weingarten
Nurit Sprecher
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)