Skip to main content

Conveying path setup type in PCEP messages
draft-ietf-pce-lsp-setup-type-04

The information below is for an old version of the document.
Document Type Expired Internet-Draft (pce WG)
Authors Siva Sivabalan , Jeff Tantsura , Ina Minei , Robert Varga , Jonathan Hardwick
Last updated 2017-10-29 (Latest revision 2017-04-27)
Replaces draft-sivabalan-pce-lsp-setup-type
Stream Internet Engineering Task Force (IETF)
Formats
Expired & archived
plain text xml htmlized pdfized bibtex
Reviews
Stream WG state Waiting for WG Chair Go-Ahead
Revised I-D Needed - Issue raised by WGLC
Document shepherd Julien Meuric
IESG IESG state Expired
Consensus boilerplate Yes
Telechat date (None)
Responsible AD (None)
Send notices to Julien Meuric <julien.meuric@orange.com>
This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at:
https://www.ietf.org/archive/id/draft-ietf-pce-lsp-setup-type-04.txt

Abstract

A Path Computation Element can compute traffic engineering paths (TE paths) through a network that are subject to various constraints. Currently, TE paths are label switched paths (LSPs) which are set up using the RSVP-TE signaling protocol. However, other TE path setup methods are possible within the PCE architecture. This document proposes an extension to PCEP to allow support for different path setup methods over a given PCEP session.

Authors

Siva Sivabalan
Jeff Tantsura
Ina Minei
Robert Varga
Jonathan Hardwick

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)