PIM Join Attributes for LISP Environments

The information below is for an old version of the document
Document Type Expired Internet-Draft (pim WG)
Last updated 2015-06-22 (latest revision 2014-12-19)
Replaces draft-arango-pim-join-attributes-for-lisp
Stream IETF
Intended RFC status Experimental
Expired & archived
pdf htmlized bibtex
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This document defines two PIM Join/Prune attributes that support the construction of multicast distribution trees where the root and receivers are located in different LISP sites. These attributes allow the receiver site to select between unicast and multicast transport and to convey the receiver RLOC address to the control plane of the root xTR.


Jesus Arango (jearango@cisco.com)
Stig Venaas (stig@cisco.com)
Isidor Kouvelas (kouvelas@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)