Using HTTP as a Transport Protocol for CMP
draft-ietf-pkix-cmp-http-00
| Document | Type |
Expired Internet-Draft
(pkix WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | Dr. Carlisle Adams , Amit Kapoor | ||
| Last updated | 1999-08-10 | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes how to layer [CMP] over [HTTP]. A simple method for doing so is described in section 5.4 of [CMP], but that method does not accommodate a polling mechanism, which may be required in some environments. This document specifies an alternative method which uses the polling protocol defined in section 5.2 of [CMP]. A new Content-Type for messages is also defined.
Authors
Dr. Carlisle Adams
Amit Kapoor
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)