Reliable Fibre Channel Transport Over MPLS Networks
draft-ietf-pwe3-fc-flow-00
Document | Type |
Expired Internet-Draft
(pwe3 WG)
Expired & archived
|
|
---|---|---|---|
Authors | Moran Roth , Ronen Solomon , Munefumi Tsurusawa | ||
Last updated | 2009-01-15 | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | Dead WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Expired | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
A Fibre Channel pseudowire (PW) is used to carry Fibre Channel frames over an MPLS network. This enables service providers to offer "emulated" Fibre Channel services over existing MPLS networks. This document specifies the mechanisms controlling the reliable transport of Fibre Channel PW over MPLS networks. The encapsulation of Fibre Channel PDUs within a pseudowire and the procedures for using a PW to provide a Fibre Channel service are specified in [FC-encap].
Authors
Moran Roth
Ronen Solomon
Munefumi Tsurusawa
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)