TDM Service Specification for Pseudo-Wire Emulation Edge to Edge (PWE3)
draft-ietf-pwe3-sonet-vt-00
| Document | Type |
Expired Internet-Draft
(pwe3 WG)
Expired & archived
|
|
|---|---|---|---|
| Author | Prayson Pate | ||
| Last updated | 2002-08-07 | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | Dead WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes the service-specific implementation and requirements for Pseudo-Wire Emulation Edge-to-Edge (PWE3) of TDM circuits using SONET/SDH payload formats over packet networks using IP or MPLS. This draft extends SONET/SDH SPE emulation proposal [CEP-SPE], providing SONET VT1.5/2/3/6 and SDH VC-11/12/2 circuit emulation. This draft also provides bandwidth saving modes for SONET STS-1 and SDH VC-3/4 carrying tributaries or asynchronous T3/E3 signals. This proposal is optimized for VT level cross connect applications, for PDH to SONET/SDH emulation and for carrying PDH circuits across a PSN. The applicability statement for TDM circuit emulation (PDH and SONET/SDH) is described in [TDM- APP].
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)