RADIUS Attributes for Multilink PPP Banwidth Allocation Control
draft-ietf-radius-ms-ba-attr-01

Document Type Expired Internet-Draft (radius WG)
Last updated 1998-02-25
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-radius-ms-ba-attr-01.txt

Abstract

This document describes a set of vendor-specific RADIUS attributes designed to support the dynamic control of bandwidth allocation in mul- tilink PPP [1]. Attributes are defined that specify whether use of the PPP Bandwidth Allocation Protocol [2] is allowed or required on incoming calls, the level of line capacity (expressed as a percentage) below which utilization must fall before a link is eligible to be dropped, and the length of time (in seconds) that a link must be underutilized before it is dropped.

Authors

Glen Zorn (glenzorn@hotmail.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)