Designing Tunnels for Interoperability with RSVP
draft-ietf-rsvp-tunnels-interop-00
Document | Type |
Expired Internet-Draft
(rsvp WG)
Expired & archived
|
|
---|---|---|---|
Author | John J. Krawczyk | ||
Last updated | 1997-03-12 | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Expired | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo provides information for designers of tunneling protocols that use IP-in-IP encapsulation. It describes how to design a tunnel header so that RSVP [RSVPv1] can be used to signal the Quality of Service requirements for individual flows within an IP-in-IP tunnel.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)