Simple Internet Protocol Plus (SIPP): DHCP Options and BOOTP Vendor Extensions
draft-ietf-sipp-dhcpopt-01
Document | Type |
Expired Internet-Draft
(sipp WG)
Expired & archived
|
|
---|---|---|---|
Author | Dr. Susan Thomson | ||
Last updated | 1994-03-24 | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | parcftp.xerox.com%3A%20pub/sipp | ||
Stream | WG state | WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Expired | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This draft defines new options in the Bootstrap Protocol (BOOTP) and the Dynamic Host Configuration Protocol (DHCP) to enable SIPP hosts, that are also IPv4-capable, to configure themselves automatically. The options enable a SIPP host to derive an address sequence, determine the scope of IPv4 reachability and discover the address sequences of default SIPP routers. The options are intended to be useful to SIPP hosts that conform to the SIPP transition specification, and operate in sites with minimal SIPP deployment. Terminology defined in the SIPP Routing and Addressing Specification and the DHCP Specification applies here.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)