Skip to main content

Path Segment for SRv6 (Segment Routing in IPv6)
draft-ietf-spring-srv6-path-segment-03

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Active".
Expired & archived
Authors Cheng Li , Weiqiang Cheng , Mach Chen , Dhruv Dhody , Yongqing Zhu
Last updated 2022-05-31 (Latest revision 2021-11-27)
Replaces draft-li-spring-srv6-path-segment
RFC stream Internet Engineering Task Force (IETF)
Formats
Additional resources Mailing list discussion
Stream WG state WG Document
Document shepherd (None)
IESG IESG state Expired
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Segment Routing (SR) allows for a flexible definition of end-to-end paths by encoding an ordered list of instructions, called "segments". The SR architecture can be implemented over an MPLS data plane as well as an IPv6 data plane. Currently, Path Segment has been defined to identify an SR path in SR-MPLS networks, and is used for various use-cases such as end-to- end SR Path Protection and Performance Measurement (PM) of an SR path. This document defines the Path Segment to identify an SRv6 path in an IPv6 network.

Authors

Cheng Li
Weiqiang Cheng
Mach Chen
Dhruv Dhody
Yongqing Zhu

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)